Marine

Significantly reduces the ability of clams, sea cucumbers, mussels and other unwanted marine creatures and plants to attach to the boat. Significantly easies the cleaning of the boat of the same mentioned previously. After treatment the gloss and finish will make the exterior of the boat look like new, even a faded dull boat will appear almost as new.

Application

Wash and completely all surfaces to be treated.

If necessary use tar remover and rinse off.

Use a claybar with lubricant to clean all surfaces to be treated. If paint correction is required do so before application.

Polish the paint.

Clean the paint using a 50% Isopropanyl Alcohol (50% IPA + 50% distilled water) or approved pre cleaner in a trigger sprayer. Mist the paint then wipe down with a microfiber tower to remove all wax, silicone, clay lubricant residues.

Spray with HVLP gun 1 mm tip on surfaces. No buffing required. (It is possible to apply with sponge by hand, then buffing is required, after 30-90 seconds, depending on temperature and conditions, use a microfiber towel for buffing. We do not recommend using this technique.)

Technical data

Effectiveness – 1 year in most marine applications

Pencil hardness – 9H

Application – Spray on with HVLP gun with 1 mm tip

Shelf time – 1 year from delivery, unopened stored at 18° C

Apearance – Clear

Film thickness – 0,75 – 1 µm

Chemical resistance – Excellent, 5% Na2CO3 for 24 hours: No visible damage, 5% H2SO4 for 24 hours: No visible damage, and 5% NaCL for 96 hours: No visible damage.

Temperature resistance – > 760° C

Salt Spray – ASTM B117 > 350 hours to first sign of corrosion

Adhession cross-cut tape – ASTM D3359 5b (no coating loss)

Mandrel bend – ASTM D522 0 mm coating loss at 180° rotation

Impact – ASTM D2794 80/80 inch/lb

Coverage – 18.5 m2/100 ml

Dry time – 20 minutes

Cure time – Initial cure in 4 hours, full cure in 3 days